Shrinkage ratio is 3:1
Temperature Start to shrink: 80?
Temperature iron start to melt: 138?
?How to use:
1.Run one wire through the butt connector tube of appropriate size, have the wires connected and treated properly, and move the connector such that the solder ring section is aligned with the wire connection;
2.Heat both ends of the tube using a heat gun so that they shrink. The waterproof rings when heated turns into waterproof rings;
3.Heat the solder ring with a heat gun until the ring melts and penetrates into the wire connection;
Warning:Heat the heat shrink tube section until it shrinks tightly around the wires; excessive heating will melt down the heat shrink tube completely. The solder ring must be heated to a full melting so as to penetrate into the wire connection.
30xRed Connectors: Diameter 2.7 mm, Cable cross-section 0.5-1.0 mm²(A.W.G.:22-18);
30xBlue Connectors: Diameter 4.5 mm, Cable cross-section 1.5-2.5 mm²(A.W.G.:16-14);
30xYellow Connectors: Diameter 6.0 mm, Cable cross-section 4.0-6.0 mm²(A.W.G.:12-10);